/ Accelerators


Low-noise pulsed current source for magnetic-field measurements of magnets for accelerators


Omelyanenko, M.M. (Dubna, JINR) ; Borisov, V.V. (Dubna, JINR) ; Donyagin, A.M. (Dubna, JINR) ; Khodzhibagiyan, H.G. (Dubna, JINR) ; Kostromin, S.A. (Dubna, JINR) ; Makarov, A.A. (Dubna, JINR) ; Shemchuk, A.V. (Dubna, JINR)

Published in: Phys.Part.Nucl.Lett.
Year: 2017
Vol.: 14    Num./Issue: 1
Page No: 219-226
Pages: 8
Year: 2017-02-19 published

Abstract: The schematic diagram, design, and technical characteristics of the pulsed current source developed and produced for the magnetic-field measurement system of superconducting magnets for accelerators are described. The current source is based on the current regulator with pass transistor bank in the linear mode. Output current pulses (0–100 A) are produced by utilizing the energy of the preliminarily charged capacitor bank (5–40 V), which is additionally charged between pulses. The output current does not have the mains frequency and harmonics ripple. The relative noise level is less than–100 dB (or 10$^{–5}$) of RMS value (it is defined as the ratio of output RMS noise current to a maximal output current of 100 A within the operating bandwidth, expressed in dB). The work was performed at the Veksler and Baldin Laboratory of High Energy Physics, Joint Institute for Nuclear Research (JINR).


Note: *Temporary record*

Total numbers of views: 140
Numbers of unique views: 54
DOI: 10.1134/S1547477117010216
 Record created 2017-03-02, last modified 2017-03-02



Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)